#
# TP-Link TL-WR1043nd v2 - based on the AP135 reference design.
#
# This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
# 64MiB RAM and an AR8327 5-port gigabit ethernet switch.
#
#

#NO_UNIVERSE

# Include the default QCA955x parameters
include         "std.QCA955X"

ident           TL-WR1043NDv2

# Override hints with board values
hints           "TL-WR1043NDv2.hints"

options         AR71XX_REALMEM=(64*1024*1024)

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO	# Export an MDIO bus separate from arge
device		miiproxy	# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch

# read MSDOS formatted disks - USB
options 	MSDOSFS

# Enable the uboot environment stuff rather then the
# redboot stuff.
options 	AR71XX_ENV_UBOOT

# uzip - to boot natively from flash
device		xz
options 	GEOM_UZIP

# Used for the static uboot partition map
device          geom_map

# yes, this board has a PCI connected atheros device
#device		ath_pci
#options 	AR71XX_ATH_EEPROM
#device		firmware		# Used by the above
#options 	ATH_EEPROM_FIRMWARE

# Boot off of the rootfs, as defined in the geom_map setup.
options 	ROOTDEVNAME=\"ufs:map/rootfs.uzip\"

# Default to accept
options		IPFIREWALL_DEFAULT_TO_ACCEPT