#
# Specific board setup for the Picostation M2 HP board.
#
# This board has the following hardware:
#
# + AR7241 CPU SoC
# + AR9287 Wifi
# + Integrated switch (XXX speed?)
# + 8MB flash
# + 32MB RAM
# + uboot environment

#NO_UNIVERSE

include		"std.AR724X"
ident		"PICOSTATION_M2HP"
hints		"PICOSTATION_M2HP.hints"

options 	AR71XX_REALMEM=32*1024*1024

options 	AR71XX_ENV_UBOOT

# Limit inlines
makeoptions	INLINE_LIMIT=768

# We bite the performance overhead for now; the kernel won't
# fit if the mutexes are inlined.
options 	MUTEX_NOINLINE
options 	RWLOCK_NOINLINE
options 	SX_NOINLINE

# There's no need to enable swapping on this platform.
options 	NO_SWAPPING

# For DOS - enable if required
# options 	MSDOSFS

# uncompress - to boot read-only lzma natively from flash
device		xz
options 	GEOM_UZIP
options 	ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"

# Not enough space for these..
nooptions 	INVARIANTS
nooptions 	INVARIANT_SUPPORT
nooptions 	WITNESS
nooptions 	WITNESS_SKIPSPIN
nooptions 	DEBUG_REDZONE
nooptions 	DEBUG_MEMGUARD

# Used for the static uboot partition map
device          geom_map

# Options needed for the EEPROM based calibration/PCI configuration data.
options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
device		firmware		# Used by the above

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO		# Export an MDIO bus separate from arge
device		miiproxy		# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch

# Enable GPIO
device         gpio
device         gpioled