#
# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
#
# The Engenius ENH-200 has the following hardware:
#
# + AR7240 CPU SoC
# + AR9285 Wifi
# + Integrated switch
# + 8MB flash
# + 32MB RAM
# + uboot environment

#NO_UNIVERSE

include		"std.AR724X"
ident		"ENH200"
hints		"ENH200.hints"

options 	AR71XX_REALMEM=32*1024*1024

options 	AR71XX_ENV_UBOOT

# For DOS - enable if required
options 	MSDOSFS

# uncompress - to boot read-only lzma natively from flash
device		xz
options 	GEOM_UZIP
options 	ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"

# Used for the static uboot partition map
device          geom_map

# Options needed for the EEPROM based calibration/PCI configuration data.
options 	AR71XX_ATH_EEPROM	# Fetch EEPROM/PCI config from flash
options 	ATH_EEPROM_FIRMWARE	# Use EEPROM from flash
device		firmware		# Used by the above

# Options required for miiproxy and mdiobus
options 	ARGE_MDIO		# Export an MDIO bus separate from arge
device		miiproxy		# MDIO bus <-> MII PHY rendezvous

device		etherswitch
device		arswitch