/*- * Copyright (c) 2009-2010 Weongyo Jeong * All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer, * without modification. * 2. Redistributions in binary form must reproduce at minimum a disclaimer * similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any * redistribution must be conditioned upon including a substantially * similar Disclaimer requirement for further binary redistribution. * * NO WARRANTY * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY * AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL * THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, * OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER * IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF * THE POSSIBILITY OF SUCH DAMAGES. */ #ifndef __IF_BWN_DEBUG_H__ #define __IF_BWN_DEBUG_H__ enum { BWN_DEBUG_XMIT = 0x00000001, /* basic xmit operation */ BWN_DEBUG_RECV = 0x00000002, /* basic recv operation */ BWN_DEBUG_STATE = 0x00000004, /* 802.11 state transitions */ BWN_DEBUG_TXPOW = 0x00000008, /* tx power processing */ BWN_DEBUG_RESET = 0x00000010, /* reset processing */ BWN_DEBUG_OPS = 0x00000020, /* bwn_ops processing */ BWN_DEBUG_BEACON = 0x00000040, /* beacon handling */ BWN_DEBUG_WATCHDOG = 0x00000080, /* watchdog timeout */ BWN_DEBUG_INTR = 0x00000100, /* ISR */ BWN_DEBUG_CALIBRATE = 0x00000200, /* periodic calibration */ BWN_DEBUG_NODE = 0x00000400, /* node management */ BWN_DEBUG_LED = 0x00000800, /* led management */ BWN_DEBUG_CMD = 0x00001000, /* cmd submission */ BWN_DEBUG_LO = 0x00002000, /* LO */ BWN_DEBUG_FW = 0x00004000, /* firmware */ BWN_DEBUG_WME = 0x00008000, /* WME */ BWN_DEBUG_RF = 0x00010000, /* RF */ BWN_DEBUG_XMIT_POWER = 0x00020000, BWN_DEBUG_PHY = 0x00040000, BWN_DEBUG_EEPROM = 0x00080000, BWN_DEBUG_HWCRYPTO = 0x00100000, /* HW crypto */ BWN_DEBUG_FATAL = 0x80000000, /* fatal errors */ BWN_DEBUG_ANY = 0xffffffff }; #ifdef BWN_DEBUG #define DPRINTF(sc, m, fmt, ...) do { \ if (sc->sc_debug & (m)) \ printf(fmt, __VA_ARGS__); \ } while (0) #else /* BWN_DEBUG */ #define DPRINTF(sc, m, fmt, ...) do { (void) sc; } while (0) #endif /* BWN_DEBUG */ #define BWN_ERRPRINTF(sc, ...) do { \ printf(__VA_ARGS__); \ } while (0) #define BWN_DBGPRINTF(sc, ...) do { \ printf(__VA_ARGS__); \ } while (0) #define BWN_WARNPRINTF(sc, ...) do { \ printf(__VA_ARGS__); \ } while (0) #endif /* __IF_BWN_DEBUG_H__ */